The product
The base coat of the Microrock system: two layers at 2 to 3 mm total. Because the Microrock line is highly waterproof, no pore filler is needed before sealing.
Where it is used
Substrates
Application data
Coverage, thickness, mix and cure, as declared by the manufacturer. Site conditions in the Gulf sit at the top of most of these ranges — allow for it in the programme.
Performance data
Every figure below is reproduced from the manufacturer's own technical data sheet, with the test standard it was measured against. The sheet itself is in the download section.
Where not to use it
The limits are as much a part of the specification as the performance. Everything here is stated on the manufacturer's data sheet.
Microcement base: Cemher Microrock Base two-component microcement applied in two layers to a total thickness of 2–3 mm on the prepared substrate. No primer to be used. Substrate to have minimum 25 N/mm² compressive strength and 1.5 N/mm² pull-off. Allow 6–8 hours drying before the finish coats.
Square brackets mark the choices that belong to the project. Send us the finishes schedule and we will return the clause completed, with the sample and mock-up programme against it.
Documents
Every document is the manufacturer's own, reproduced in full and unaltered under our cover. Free to download, no form.
The rest of the
Technical support for the design team
We supply the material and we apply it, so the specification and the workmanship sit with one party. Send a finishes schedule, an elevation or a mood board and we will come back with the system, the build-up, the sample programme and a completed clause.