Clayworks, from Cornwall to the Gulf
Clayworks makes unfired natural clay plasters in Cornwall, United Kingdom. The clay is blended, coloured and bagged rather than fired, which is why the finished surface stays breathable and carries its colour through the body. The company holds the King's Award for Enterprise 2023.
Earth Layers is Clayworks' sole authorised distributor and approved applicator across the Middle East. We hold the range in Dubai and apply it with our own crews. The artisans are on our payroll and trained on the system, not brought in project by project.
For a specifier that means one party for the whole wall. Material and workmanship sit under a single warranty, so there is no gap between supply and application to argue over when a sample, a substrate condition or a snag needs resolving. One point of contact from mock-up to handover.
clay-works.com →Why clay
Humidity held steady
Clay takes up moisture when a room is damp and releases it when the air dries, helping hold interiors between 40 and 60% RH. In a Gulf climate, where air conditioning swings a room hard, that buffering keeps wall surfaces and occupants more comfortable.
Colour through the body
The colour is in the clay itself, not a coat sitting on top of it. A knock or a scuff shows the same colour underneath, and repairs blend into the wall rather than patching over it. Clayworks references run from Nude NUD-01 and White WHI-07 to Terracotta TER-03.
Nothing to off-gas
The plasters are mineral and unfired, with no solvents or plastic binders to release into the room after handover. Walls are ready to live with straight away, which matters in bedrooms, clinics, schools and any space that is occupied all day.
Support for green ratings
Clay plaster contributes to WELL, LEED and Mostadam submissions through material health, low emissions and indoor comfort criteria. The documentation library below carries the data sheets your consultant will ask for at submittal stage.
The range
Four classic interior finishes, a wet-area finish, a rammed earth look for interior walls, and a dedicated exterior system. Every one of them is held in the region and applied by our own artisans.







Custom finishes
Custom finishes are the part of the range where texture is designed for a project rather than chosen from a shelf. We start from a drawing, a reference or a material sample, then make control panels on site in the specified Clayworks colour — Nude NUD-01, White WHI-07, Terracotta TER-03 — and adjust depth, direction and grain until the wall reads the way the design intends. Every finish below is for interior walls and ceilings, applied by our own crews.





















Featured projects
Built with this material, by our own artisans. Open the project for the full set of photographs and the story of the installation.
Technical library
The range is fully documented for specification and submittal. The library carries technical data sheets issued under our own cover, light reflectance values for daylight and lighting calculations, and the Auro primer sheet covering substrate preparation. Ask us if a consultant needs anything the library does not already hold.
Sample it, then specify it
We will make as many trial panels as it takes to arrive at the surface you want, on the substrate you are building on. Send the finishes schedule, or come to the showroom in Riyadh and put a hand on the range.

