The product
The non-UV grade of Stonebound, with a tighter application window than the UV version. The resin darkens in sunlight, so it belongs in sheltered or colour-tolerant locations.
Where it is used
Substrates
Application data
Coverage, thickness, mix and cure, as declared by the manufacturer. Site conditions in the Gulf sit at the top of most of these ranges — allow for it in the programme.
Performance data
Every figure below is reproduced from the manufacturer's own technical data sheet, with the test standard it was measured against. The sheet itself is in the download section.
Where not to use it
The limits are as much a part of the specification as the performance. Everything here is stated on the manufacturer's data sheet.
Resin bound surfacing: Addagrip Stonebound Non UVR polyurethane resin bound aggregate surface course, [10] mm aggregate laid [22] mm thick to the approved sample panel. Applied between +7 °C and 25 °C. Contractor to advise the Architect in writing that the resin darkens under UV exposure. Permeability to BS EN 12697-40:2005. 7 days full chemical cure.
Square brackets mark the choices that belong to the project. Send us the finishes schedule and we will return the clause completed, with the sample and mock-up programme against it.
Documents
Every document is the manufacturer's own, reproduced in full and unaltered under our cover. Free to download, no form.
The rest of the
Technical support for the design team
We supply the material and we apply it, so the specification and the workmanship sit with one party. Send a finishes schedule, an elevation or a mood board and we will come back with the system, the build-up, the sample programme and a completed clause.
